Have just purchased a brand new fuel filler cap from partsworld-uk.com which is excellent value and looks very nice. My existing one is a bit tarnished and have never got around to refurbishing it so the cost of a new one seemed a good compromise.
I have now fitted the new one but when swapping over the lock barrel I found that the latch part of the new one (the bit where the lock fits) when the lock was inserted it would only turn a quarter turn instead of a half turn. When looking at the old one, the groves inside the barrel receptacle look different in that the old one has sort of two key ways and the new one only has one. I know this probably isn't very well explained but to solve the problem I have had to fit the old latch part with the barrel in to the new body. It looks OK but the old latch part is a bit tarnished and obviously isn't as good as the new one.
Is anybody aware that this is a known problem or am I doing something wrong possibly?
My car is a year 2000 Plus
Thanks
John
p.s. I did get hold of a second hand one a year or so ago with a view to refurbishing it but looking at the latch assembly on that one I think it looks like the new one as well - IE it wouldn't fit properly either!
Re: Fuel Filler Cap Lock
[Re: Lappers]
#1627429 29/11/201820:3929/11/201820:39
After removing both screws which hold the plate in place I found this plate was different from my original cap so I used this old plate and it worked fine.
Re: Fuel Filler Cap Lock
[Re: Lappers]
#1627447 30/11/201814:2830/11/201814:28
Thanks John, might give that a try but I found the barrel would only go in the housing in one particular position when it was all apart so I’m not sure the grooved plate will have any effect but will see!
Re: Fuel Filler Cap Lock
[Re: Lappers]
#1627509 03/12/201810:4903/12/201810:49