Ok I have a sub and amp that are 2ohm stable but I have lost the instructions on how to wire it up so it will run 2ohm stable.
Can some one tell me how with a pick if possible
Thanks Bernie

Many manufacturers have manuals available to donwload from their websites.

Just thought I would ask on here first

Should be dead easy mate but without knowing what components you have, hard to give an accurate response.
Would hazard a guess that you don't have many options though if we're talking about a single sub...

I have the Audiobahn AWES12P sub and the Audiobahn A1500HCT amp so i decided that I only need 1 sub as I run 147db at a meenstreet cruse a few years back .
didcoop will tell you how loud it was in the back of my punto

it'll be series or parrallel wired

if i remember right being a dual 4ohm
if you do + to + from one coil to over and - to - on the other it will bring the ohm down

then + to - from one coil and +to - on the other will increase the ohm

this is from memory

meanstreet, ain't been there in years.

Competed in db drag at trax last year with my celica ended up with a 3rd place

I did say a few years back . It must be about 3 years ago now. It was a dump but it was always a good giggle